Like a sulphur stick (sulfer stick) to burn inside barrels to sanitise
Each ring is about 10g
Avoid skin contact. Wash well with soap and water if skin contact occurs. Avoid any contact with eyes.
Hang the sulphur ring inside the barrel; do not have it contact the barrel surfaces while it's burning.
Suggest having a piece of wire attached to the bung, with a hooked end to hang the sulphur ring on.
Steps are:-
- Wash and drain the barrel
- Turn it back up the right way with the bunghole at the top
- Hang the sulphur ring on the wire hook and light it, then place so it is hanging inside the barrel. The bung should sit loosely (angled is good) in the bunghole just to hold it in place, but not pushed down into the hole to avoid it popping out when pressure builds up inside the barrel as the ring burns. If the ring doesn't stay alight it is usually because it is too humid inside the barrel, so you might need to wait for some steam to escape after washing
- Once the ring has fully burned you can carefully lift out the burnt ring and then push in a clean barrel bung
- Repeat periodically (once every couple of months or so) to keep the barrels sanitised
- Wash barrel out prior to filling with juice/wine to remove any residual sulphur